www.pexuniverse.com PexUniverse - PEX, Plumbing, Heating, HVAC Supplies Industrial equipment supplier in Brooklyn, New York
3" Innoflue SW Tee Cap w/ Drain
Brand: Centrotherm
Part#: ISTCD03
This product has been discontinued. No direct replacement is available at this time.
Allows for vertical condensate drainage in a 3" Innoflue SW (Single Wall) vent pipe system. Drain OD is 1.26". Requires IANS03 connector ring (not included). Install using IACE50 Centrocerin.

Features:
  • Innoflue SW (Single Wall) is the only polymer vent system on the market listed to UL 1738
  • Accepted and approved by over 50 North Amercian manufacturers of boilers, water heaters and furnaces
  • Suitable for natural gas, propane and fuel-oil condensing and non-condensing (flue temp. below 248°F) appliances
  • All parts (pipe, fittings, etc. - both black and grey) are UV resistant and suitable for indoor or outdoor installation
  • Requires no primer/glue and does not leach chloride like PVC & CPVC
  • Costs less and is faster and easier to install than stainless steel venting, no special tools needed, zero clearance to combustibles
  • Industry-leading 2mm wall thickness
  • Built-in gasket allows for adhesive-free installation which can be adjusted at any time
  • May be installed through a wall, chimney, chase or between joists
  • Lightweight, requires minimal support
  • Made in the USA from environmentally-friendly PolyPropylene (PP).
Write a Review
Helpful? Yes {{ (2*reviews[i].feedback_helpful) - reviews[i].feedback_count }} No
Verified Purchase
{{ reviews[i].content.title }}
Reply from PexUniverse:
By {{ reviews[i].content.name }} (from {{ reviews[i].content.location }}) on {{ reviews[i].created_at | formatDate }}
Ask a Question
{{ f.question }}
Helpful? Yes {{ (2*f.feedback_helpful) - f.feedback_count }} No
By PexUniverse Customer Service on {{ f.answered | formatDate }}

Recently viewed products

Top