UP10-16PMBN5/LC Comfort Pump w/ Line Cord, 1/2" FNPT, 115/208-230V
Brand: Grundfos
Part#: 98420210
In Stock
Usually ships: within 1 business days

Grundfos Comfort UP 10-16 PM pump is designed for recirculation of domestic hot water in single-family homes with dedicated hot-water return piping. Utilizing a low-noise permanent magnet motor, energy consumption is reduced to as little as 5 - 8.5 W.


Features:
  • Easy installation
  • Minimize water waste
  • Lower energy consumption.

Technical Specifications:
  • Connection: 1/2" FNPT
  • Flow Range: 0-2.2 GPM (0-0.5 m³/h)
  • Head Range: 0-3.9 ft (0-1.2 m)
  • Phase: 1
  • Housing: EcoBrass
  • Maximum Liquid Temperature: 185°F (85°C)
  • Minimum Liquid Temperature: 36° (2°C)
  • Maximum System Pressure: 145 psi (10 bar)
  • Voltage: 115/208-230V
  • Amperage: 0.23 Amps
  • Power: 5-8.5 Watts.
 
Read more
Write a Review
Helpful? Yes 4 No
Nearly silent, energy efficient, what more could you want
Installation is in a 5,000 sq ft 3-story home with a return line run from the farthest point (top floor MBR) to the basement water heater. The pump was installed at the heater to push water into the drain line fitting in the bottom of the tank.The pump is nearly silent in operation; you have to get within a foot or two to hear it at all. It also draws only 5.5 watts according to my watt meter, which is only $5 a year in SC. And it works well, we now have only a few seconds wait for hot water where before it was nearly 2 minutes.HINT - if the pump makes any noise there is air in the line. That will not only cause excessive wear on the pump but it will not circulate water, as it is stuck with a big air bubble in the pump. Purge the air out until the pump goes quiet and it will work great.
By Bob in SC (from South Carolina) on 05/11/2016
Ask a Question
Can this be a replacement for a 96433897 pump?
Helpful? Yes 1 No
Yes, this is a direct replacement for the older Grundfos UP10-16BN5/LC (96433897) model.
By PexUniverse Customer Service on 09/01/2015

Related products

Top