Tube Talons for 1/2" PEX Tubing, Copper, CPVC (100/bag)
Brand: Everhot
Part#: PXA4411
In Stock
Usually ships: within 1 business days

Tube Talons (J-Clamps) with Nail. Compatible with 1/2" PEX tubing, 1/2" copper pipes and 1/2" CPVC pipes. Can be used to secure tubing / piping to wooden surfaces,such as joists, studs, beams, subfloor, etc. Designed to offset the tubing from the mounting surface and eliminate or reduce noise problems associated with thermal changes in the plumbing/heating system. Protruding nail length (wood penetration depth) is 5/8".

Write a Review
Helpful? Yes No
Verified Purchase
Wouldn't buy anything else
These were perfect for installing in the floor joists for my radiant heating. With the rim-shank nails makes these hooks hard to pull off! When the 1/2" tubing would try to twist I just put one or two more in that area and it's holding beautifully! Would highly recommend this product!
By Mike C (from NY) on 10/15/2015
Helpful? Yes No
Verified Purchase
Great product
Should have ordered more. Fit perfect.
By Cabin builder (from Southern oh) on 10/13/2015
Helpful? Yes No
Verified Purchase
does the job
Good product. . Works as expected.. priced right!
By Verified Buyer (from nj) on 06/28/2015
Helpful? Yes No
Verified Purchase
Tube talons
These 1/2" pex hold downs work great to secure pex. Great low cost solution.
By Glen S. (from Oxford, GA) on 03/01/2012
Helpful? Yes No
Worked great and reasonably priced.
"These neat pipe holders hammer in quickly and securely anchor in just seconds! You can pre-click them onto the pipe, hold the pipe in place and hammer it into place. Or, you can hold the clip over the pipe in one hand and tap, tap, tap on the nail and the clamp will expand and clip over the tubing as you hammer it in. Great product!"
By computerhelperjohn (from Grants Pass, OR) on 10/10/2011
Helpful? Yes No
Very good product, would buy again.
Above floor radiant heat. Also used for non metallic electrical work.
By FREDC. (from Long Island NY) on 04/16/2011
Ask a Question
What is the spacing for 1/2" tube talons
Helpful? Yes 3 No
Horizontal pipe runs are generally supported every 2-2.5 feet. Vertical - every 3-4 feet.
By PexUniverse Customer Service on 07/17/2012

Related products

Top